Cutting machine cost savings

Cutting machine cost savings is a knowledge, can help factory to save costs and increase profits. System each part of the cost of reducing directly lead to increase profits. Cut each part can save money, thereby increasing profit margins. Cutting parts per hour, the more the more total profits will increase. The following recommendations can reduce costs, improve the production efficiency of cutting machine: 1. As far as possible to extend the time of the normal operation of the machine: cutting machine should be used for cutting. Preventive maintenance is to avoid costly downtime for the maintenance of caused by the key. Material handling solutions, such as cutting bed, crown and filling machine, can greatly reduce the manual operation, ensure that operators can concentrate on cutting operation. The machine motion parameters are equally important. If the cutting torch to adjust to higher controller, or machine transverse speed too slow, the machine will spend most of the time on the cutting torch orientation, rather than cutting metal. 2. To minimize the secondary processing: by optimizing the cutting quality to control the cost of the secondary processing. To do this, not only to the proper maintenance of the machine, and to make a good training for operators. Skilled operators can produce more cutting piece, higher quality, reduce waste and rework. To obtain good cutting quality, in the process of cutting process parameters need to carefully control, meticulous to do. 3. Control the cost of wearing parts: wearing parts and control the cost of cutting quality, part depends on equipment, part depends on the operating personnel. Qualified operators can make full use of various parts, to prevent the occurrence of catastrophic failure.