Cutting machine how to layout?

Before using cutting machine, we put the complete graphics into the program, and then use the typesetting software graphics arrange on a plate, cutter can batch processing products. Among them, although typesetting process is very short, but in this case, to hide a lot of knowledge, and layout slightly wrong, it will produce very big effect to the whole layout of cutting. In cutting machine typesetting, there are six questions need your attention. Melt cutting machine layout problem: 1, the corner when cutting the corner of the plate to slow down, due to overheating and melting of the corner. In order to generate the small radius of the corner to keep high speed cutting, avoid cutting the corner of the molten steel overheating phenomenon, good cutting quality, reduces the cutting time, improve the productivity. 2 and the distance between parts in general, when the cutting plate and hot plate, the distance between the parts should be very big, because the heating effect of the thick plate and the hot plate is very big, easy to burn the edge when cutting Angle and small graphics, influence the cutting quality. 3, lead background in thick plate cutting process, in order to make the weld connection is good, prevent burns the beginning and end, in the beginning of the cutting and often introduce a known as lead and tail line at the end, the transition line. Lead line and stern line on the workpiece itself is useless, so they should decorate is outside the scope of the artifact, at the same time, should be careful not to set to acute Angle to avoid the heat. Fuses with the connection between the cutting seam should be used as circular arc transition, in order to make the machine run smoothly, avoid the stop Angle cause burns. 4, the cutting will be two or more than two parts are combined into a portfolio, as close as possible to mass rule pattern, which greatly shortens the time of cutting and save the raw materials. 5, parts collision in order to improve productivity to a great extent, many cutting equipment running 24 hours a day in a row, using automatic unmanned/discharging device, resulting in damage to the cutting head and was interrupted by the impact tilt production, resulting in loss of more and more. It should be paid attention to when ordering: ( 1) Select the appropriate cutting paths, bypass the cutting department, reduce collisions. Choose the cutting path, shorten the cutting time. Multiple small parts can be put together automatically or manually, and after cutting, the removed parts can be easily broken. 6, the remaining material after cutting device and cutting machine is used for disposing device frame shape for promoting the subsequent cutting operation is necessary to remove residual material as soon as possible. Cutting equipment without automatic discharging device, skeleton scrap can be cut into small pieces and promote quick removal. In this way, can avoid strenuous exercise and cause than expected sharp edge and cause personal injury to the operator.