Cutting machine typesetting process how to do? It is very important to the six o 'clock

Before cutting machine for processing, need to have many years experience of typesetting typesetting software, layout of the finished product can be imported after cutting machine, can directly carry on the processing, the use of obvious advantages. So the typesetting process directly affects the cutting machine cutting results, then detailed introduce for everybody. 1. Angle of melt when the corner of sheet steel to slow down, due to overheating and melting of Angle.
in the corner to generate small radius, to maintain high speed cutting, the cutting Angle to avoid overheating phenomenon of molten steel, good cutting quality, reduce the cutting time, increase productivity. 2. Two or more cutting edges formed part of the Shared edge combination. Big rule pattern Shared edges as far as possible. Ordinary blade cutting can greatly shorten the cutting time, saving raw materials. 3. Residue after processing cutting parts, to be removed as soon as possible cutting machine skeleton of scraps on the table, makes it easy to subsequent cutting operation.
in the absence of automatic discharge device to cut off the device, can remove the skeletal debris quickly cut into small pieces. Can avoid homework personnel sharp edges caused personal injury. 4. In general, the distance between the parts to cut off the plate and the hot plate, the distance between the artifacts should be very big. Plate heat is affected by the great heat. Cutting Angle and small graphics, easy to burn the edge influence the cutting quality. 5. Conductor is set in the process of cutting thick plate, in order to make clearance joint, to prevent burns of the head and tail, often cut off the ends of the switch. The front and tail line is the artifact itself.
no, please on the scope of the artifacts, be careful not to put the wire in sharp corner of the place that is not easy to fever. The cable is attached, and the gap of use circular arc. 6. Components conflict to a certain extent improve the efficiency of production, many cutting equipment run continuously for 24 hours, using the unmanned automatic loading and unloading device, encounter the overturned after cutting parts, cause the breakage of the cutting head and production disruptions, cause a great loss. Above is cutting machine, the detailed introduction of the typesetting process when using the typesetting process has many, need to clear some details factors will affect the quality of the workpiece, therefore need to be pay attention to. The distance between each part should also be clear, otherwise easy to burn the edge, influence the cutting quality.