2656284142@qq.com
TELL US MORE ABOUT YOUR PROJECT
Contact Sales at Zuolong
Latest products
Inspection and handling methods of cutting machine alarm
by：ZORON Machinery
2021-01-29
, cutting machine distance alarm and disarm
when cutting machine running distance beyond the set by the course, then cutting machine all the movement of the shaft will be the default Settings to dynamic state, if always hold the hand by hand the direction key, when the machine left limit position can connect motion state at any moment. But, at the time of moving workbench, must pay attention to the workbench's direction of movement must be far away from the limit position. Engraving machine software alarm can be reset to three axis in the coordinate setting.
2, cutting machine and alarm failure
distance alarm is cutting machine at work in the process of operation, has reached the very limit position, if there is alarm, so would you please check following these procedures:
1, cutting machine and computer are grounded properly.
2, at this moment whether the coordinate values is beyond the limit cutting machine software of numerical.
3, check the figure of the design of your size is beyond the scope of the processing.
4, check the motor shaft and screw connections have a loose, if loose, to tighten the screws.
we want more cutting machine price, welcome to inquire, hotline:
when cutting machine running distance beyond the set by the course, then cutting machine all the movement of the shaft will be the default Settings to dynamic state, if always hold the hand by hand the direction key, when the machine left limit position can connect motion state at any moment. But, at the time of moving workbench, must pay attention to the workbench's direction of movement must be far away from the limit position. Engraving machine software alarm can be reset to three axis in the coordinate setting.
2, cutting machine and alarm failure
distance alarm is cutting machine at work in the process of operation, has reached the very limit position, if there is alarm, so would you please check following these procedures:
1, cutting machine and computer are grounded properly.
2, at this moment whether the coordinate values is beyond the limit cutting machine software of numerical.
3, check the figure of the design of your size is beyond the scope of the processing.
4, check the motor shaft and screw connections have a loose, if loose, to tighten the screws.
we want more cutting machine price, welcome to inquire, hotline:
Custom message
