What are the possible factors cutter for cutting the abnormal?

Cutting machine advantage is obvious, when the cutting speed is relatively fast, in addition to cutting slot is relatively small, so when use can achieve high efficiency and high quality, it's more suitable machining, many of them are some of the metal processing industry. But cutting process will often appear some unfavorable factors, then introduce specific cutting machine cutting for you what are the possible factors of abnormal. 1. Pipe deformation is the main factor decision. Deformation can sometimes lead to the failure of cutting. The pipe rotating about its treatment scheme, a few times, not be replaced by deformation, but with good support Angle for processing. 2. Pipe out light mouth cutting machine is one of the important parts, affect the cutting result decision processing effect, the cutting performance and other operations. The parts are to be examined in this case, the tube, need to check whether the damage.
manufacturers recommend cutting processing, if it damaged, need to change in time. If there is no damaged, need to clean it first. So in the later use can achieve good effect. 3. Focus lens breakage cut off too fast, focusing lens breakage, focus is very poor, the light path is not straight, voltage instability is cutting cannot be cut off. Need to adjust focus, prevent the influencing factors of cutting precision. 4. Beam of light determines the intensity of the light beam of light road. If weaker beam, in the light path transmission processing board cut may be occurred in succession. At this time, should be testing whether the light path is located in the middle, through the middle.
no beam through hole, prone to diffraction phenomenon, tube and beam power down. In order to solve these problems, can increase the working current. Above is cutting machine for cutting the possibility of abnormal factors, need to be pay attention to when choosing cutting, can not affect the normal use of cutting machine, pipe cutting machine is the important factors that affect the cutting, therefore need to be pay attention to, can not affect the use of whole processing effect.