What is cutting machine, cutting machine introduction

What is cutting machine? It is the use of light to the traditional blades and cutting tools is difficult to process all kinds of material cutting, engraving, cutting, drilling, marking and the development of a machine tool, mainly used to compare the cutting and processing of refinement. Because do not use of blade and other parts in contact with the material, in addition to the oscillator has a certain life, do not need to change the contact parts of wear or aging and other parts. In addition, because do not contact processing, so in the process of processing, the processed material will not deformation by stress or pressure, with image processing software to transmit data directly to the processing machine. Thus, eliminating the need to ever die manufacturing process itself, and can work out a variety of goods. The system is suitable for machining medium density fiberboard (MDF) ( MDF) And metal plate 2 d shape, because the three dimensional shape processing more difficult. YAG and CO2 was once a mainstream, but the device and the proportion of high power semiconductor device is increasing. In the use of the contact such as YAG, CO2, due to rough (careless) operator in the machining process, are at risk of blindness, therefore, in the processing area between the operator and set a can open the door of the cutting machine, and on the cutting machine set can detect abnormal processing area of the flame or heat, and can be sent to the operator danger alarm sensor alarm fire cutting machine, on the security is higher and higher. Specially used for metal processing cutting of large processing equipment can be fine, but this kind of equipment both in initial cost and operation cost are relatively expensive, may cause manufacturing costs soaring, according to different application, the traditional metal processing methods might be cheaper, because of the lack of operators such as human resources, importing this kind of equipment can be very expensive. Many small and medium-sized cutting machine manufacturers, can't processing metal, but specialized processing of various materials, they are using the internal oscillator mixed gas seal, the operation cost is very high. Some manufacturer use attachments oscillator, so the operator can easily change the system, without the assistance of professional and technical personnel. In addition, in about 2015 years before, even cheap models, each installation cost is high, but can greatly simplify the optical optical system of high power semiconductor device is cheaper and cheaper, in recent years, the personal equipment also began selling low cost.