Flame cutting machine can cut the thickness of the material?

Flame cutting machine can cut the thickness of the material? This process can cut most of the metal plate thickness of the material. Before 1958, when the body come out, all the thickness of the material is flame cutting. Today, more than 3/8 - 1/2 thinner metal usually can only be used or cutting, because is very challenging for flame cutting thin materials. Thin materials need to be very strong preheating, because of high quality required for cutting cutting speed is very high, so you need to high temperature and high speed preheat. All the thickness of the cutting process is the same, namely the material needs to be & quot; Preheating & quot; By 1600 - The temperature of 1800 degrees Fahrenheit, then pure oxygen emissions to preheat area, and then steel by oxidation or burning, so called & quot; Combustion & quot; 。 ( ” Burner & quot; The term is often used for the operator. ) Above the cutting surface quality can be quite good, sharp, cutting face founder/flat, under sharp without slag. Flame cutting machine flame cutting method and the traditional combination of automation technology can be used to cut the carbon plate thickness over 6 mm and ordinary carbon plate. Considering the usage of steel in the domestic market, flame cutting is still occupied a large market. Flame cutting machine cutting and cutting machine cutting in a different way. Flame cutting is using high temperature flame to heat a point on the surface of the steel plate to ignition point, and filling the hyperbaric oxygen incision which created its burning a way of cutting. Normally, gas and oxygen flame cutting need, there are three kinds of gas for the flame: gas, acetylene and propane. Among them, the coal gas calorific value is small, propane, acetylene is very big. Calorific value, the greater the cutting speed faster, the faster the burning, cutting, the better the results. Flame cutting can easy oxidation of metal cutting, and it is hard to cut high carbon content of flame. In general, the thickness of the flame cutting is more than 6 mm carbon steel. Although under 6 mm steel plate can be cut, but because of with thin steel plate, the method of flame cutting is using high temperature flame to heat a point on the surface of the steel plate to ignition point, and filling the hyperbaric oxygen combustion form cutting. As a result, when cutting steel plate is easy to cause the thermal deformation, after cutting the steel plate cannot achieve good effect. General flame cutting machine can cut up to 200 mm, specially after reconstruction can be cut to 350 mm. On the cutting speed, flame cutting many times faster than manual cutting. But a little slower than cutting. Comparison of 20 mm thick plate. Flame cutting speed is about 450 mm/min per minute, per minute cutting speed is about 1500 mm/min. Flame cutting of vertical degree is better than cutting. Flame cutting cutting surface is vertical, and the slope of the cut surface have certain cutting.