Flame cutting machine heating phenomenon, how to prevent? How to deal with?

The use of flame cutting machine can improve efficiency, so that they can achieve better effect, cutting machine there are many problems when use the more common is cutting machine heating phenomenon, need extra attention, need to prepare in advance prevention, overheat if also want to in a timely manner for processing. Then detailed introduce for everybody. 1 a, the overheating of the flame cutting machine to prevent technology. To reduce the fever factors of machine tool cutting machine commonly internal heat generated when the main heat source of hot deformation, should as far as possible to the heat source is separated from the host. 2. To improve the flame cutting machine tool mechanism design under the condition of same fever, cutting machine institutions also have great influence to the thermal deformation. As a tool in the past a single pillar institutions may be replaced by the double column body. Due to the left and right sides is symmetrical, dual axis line of the mast mechanism after heated in addition to produce the vertical translation, other direction deformation is small, and vertical axis movement can easily use a coordinate correction to compensate. 3. Software and hardware channels to control the temperature rise of the machine tool cutting machine after took a series of measures to reduce the heat source, thermal deformation situation will improve. Through good cooling and cooling are needed to control temperature, in order to reduce the influence of heat source. Which department is in the machine tool is a effective method of forced cooling heating parts, also can be in low temperature machine parts, by using the method of heating machine each point temperature uniformity, so that we can reduce the buckling deformation caused by temperature difference. Second, the overheating of the flame cutting machine with some customers in the use of flame cutting machine, the system is easy to heat, the cutting machine continuous work has brought great inconvenience; We mainly take the following measures to be addressed: 1. Replace the high power fan CPU, hard disk, Pay attention to the fixed disk fan, should not be installed on the hard drive firmware frame, just in case for fan rotation bring hard disk) To speed up heat dissipation. 2. Inside the chassis mounted to the casing outside the convulsions of the fans, increasing air convection; 3. Placed in the industrial control cabinet, installation of small axial flow fan; 4. In the control room equipped with air conditioning, in order to reduce room temperature. Above is the flame cutting machine heating phenomenon, how to prevent? Details about how to deal with, if found in the process of using this kind of phenomenon, can timely find fault source, processing, to prevent overheating affect the later processing operations.