How to maintenance of cutting machine?

Cutting machine the machine is a kind of sensitive current components, would be better to choose slow start circuit, and must work within the current limitation, there must be more strong surge absorbing circuit. Use at ordinary times can pay attention to, you can let machine preheating, temperature control balance will open later, can in turn off the power before every time I use down, and then shut down, boot time to raise, avoid overshoot has occurred in the circuit of the damage, and to guarantee the stability of the power supply.





to ensure the device has been in normal working condition, continuous work two weeks later or stop use after a period of time ( Ensure clean) , in the first before starting the medium diaphragm and protect glass of lens in the optical path components for inspection, determine the optical components without dust pollution, mildew and other anomalies, if you have the above phenomenon should be handled in time, ensure each optical component will not damage under strong light.

the purity of cooling water is to guarantee the output efficiency and condenser chamber key component life, in use should check once a week in circulating water conductivity, ensure its conductivity 30. 5 mw · cm, must be replaced every month circulate in deionized water, fresh water conductivity must be 32 mw · cm. Watch at any time in the cooling system, the color change of the ion exchange column once found that the color of the resin in exchange column into a dark brown or black, resin should be replaced immediately.

equipment operators can often use black paper detector output light spot, once found flare phenomenon such as uneven or energy decline, should timely adjust device of cavity, to ensure the output beam quality. Typical light spot image is as follows: adjusted the spot not tuned there after the adjustment of the cavity.

note: when strong direct illuminate to flammable items will produce flame, such as wood must be placed on the output of the light in the process of debugging a piece of black metal materials as a beam of light to absorb the good performance of termination, prevent fire accidents.

device maintenance must be carried out by specially trained personnel, otherwise easy to have serious damage.