In the use of cutting machine, on the premise of guarantee the quality of its cutting will try every way to reduce the loss of it, is there any way to reduce the wastage of the it?
cutting machine, before starting the push beam back and forth motion with the hand, the car around mobile is ringing, can only be electrified.
To complete the work in the day, should be carefully clean up the waste and debris inside the machine, so that we can make the machine movement system avoid by foreign object damage.
Clean up its moving parts, the machine can maintain good working condition, the specific method is as follows:
1, note with a little oil on the screw, including pipe support and screws on the mirror, and easy maintenance when disassembling.
Note: do not add lubricating oil to the synchronous belt, drag chain, trachea, motor, sensor and lens, electric wires.
2, the machine cannot be placed within the goods, so as not to cause unnecessary damage to the machine.
3, use cotton cleaning metal oil tankers, metal shaft, slide block, and the dust and foreign bodies on the linear guide, filling grease, hand in hand limits do reciprocating motion.
The workings of a cutter is given priority to with cutting, applied in the metal cutting.
Beam diameter of cutting machine can reach 0.
1 millimeter, on the metal material cutting diameter up to 0.
2 mm or so, therefore, the design of cutting is very precise, it not only improve the taste of art and technology content of sheet metal processing, but also improves the profit space.
So everybody must cherish when cutting machine operation, standardized operation, this equipment can better service for you.
2656284142@qq.com
