After cutting is the focus of energy to achieve high power density.
Controlled by computer, through pulse discharge, thus controlled repeated high frequency pulse output, forming a certain frequency, pulse width of the beam, the pulse beam through the light path transmission and reflection and through the focusing lens group focused on the machining surface, forming a subtle, high energy density, intensity, focal spot near to processing surface, with instantaneous high temperature melting or gasification materials processed.
Each high-energy pulse in an instant by the object surface sputtering out a tiny hole, under computer control, the processing head and processed materials according to the continuous dot relative motion paint with good graphics in advance, and will combine processing ChengXiang to the shape of the object.
Comply with the general cutting machine safety operation procedures.
In strict accordance with the initiator starter.
Operators must be trained and familiar with equipment structure, performance, and master the knowledge about operating system.
Wear labor protection articles according to regulations, near the beam should wear the safety glasses within the rules.
In did not make clear whether a particular material can be light or heat, not to its processing, in order to avoid potential danger of smoke and steam.
When the equipment is operating personnel shall not leave the job or client stay tube, such as really need to leave should be shut down or cut off the power switch.
Will put a fire extinguisher readily accessible place;
Not to switch off the device or brake light when processing;
Don't place in the vicinity of the beam without protection paper, cloth or other fuel.
In the machining process of abnormal, should stop immediately, timely troubleshooting or report to the competent personnel.
Retainer, the lathe bed and the surrounding area clean and orderly, without oil, artifacts, plank, waste stack according to regulations.
Use cylinders, should avoid to crush the welding wire, so as to avoid leakage accidents.
The use of gas cylinders, transportation shall comply with the rules of the cylinder.
Ban cylinder blasting bask in the sun or away from heat.
When you start the cylinder valves, the operator must stand in the bottle mouth side.
To abide by high pressure safety procedures for servicing.
40 hours per operation or maintenance, each work 1000 hours a week or maintenance every six months, to be carried out in accordance with the rules and procedures.
Boot should be manually after the X, Y direction to start the machine tool at low speed, check with or without abnormal situation.
For new workpiece after the input process, should first test run, and check the running status.
Pay attention to the machine running situation at work, in order to avoid cutting machine out of the valid range or two collision accident.
2656284142@qq.com
