ZuoLong mechanical explanation: how to correcting dislocation cutting machine mechanical system?

Cutting machine is cutting equipment is developing rapidly in recent years, was widely welcomed in every industry. But cutting after using for a long time, more or less will produce mechanical displacement of the system, and led to the decrease of the cutting quality of the product. So how to correct the mechanical system is particularly important, the stand or fall of mechanical system correction was directly influence the effect of the products.

axis calibration two guide unparallel axis direction by polishing, until flare up and down at the ends of the shaft is consistent; Then turn the head to move to proximal shaft; Back and forth on the axis direction, until the X axis at the bottom of remote and flare up and down in the same direction; Then turn the head at the four angles of mesa polishing, respectively, to judge the lower right corner of light and other three flare up and down are consistent; Flare upper and the lower right corner; Specify the below spot offset, for example: to relax the left guide rail below aluminum and fixed between the four screws ( The big screw at the ends of the guide rail) In the lower left corner between aluminum and fixed block add a small iron, aluminum rise and screw down the screws; And repeat step 1, check whether the light spot is consistent; , such as low plus small iron, repeated 3, ( Step until four flare up and down. Mesa not level correction, put another cloth on the table with the size of mesa tablets, to about 5 mm on it put a piece of small square.

1。 His head moved to mesa of a horn, move up and down the nozzle to the surface of the small square, and then move into another three Angle of the mesa, between the nozzle and plate with a small square respectively test the distance, such as high and low, is looking for a low Angle of them as a benchmark;

2。 Relax mesa of fixed screw, which in turn in the screw position will mesa knock down slowly, and then turn the head to move to the location, between the nozzle and plate with a small square test their distance, if it is not the same as high continue to knock down and test their height, until the height of the place and datum.

3。 Move to other places, repeat (2) Step, until the mesa height and datum, tighten all the screws used to fixed mesa. Straight Angle adjustment, on A tablet or cardboard cut the size of A rectangle of A mesa, the quantity of the diagonal line, A line of the upper right corner to the lower left corner line, line B lines to the upper left corner to the lower right corner with B shall prevail,

as A line more than 3 mm long, ( As a tooth bit by 3 mm) Will the machine on the right side of the Y direction of the synchronous belt to relax, beating the corresponding belt teeth make modulus of downward deflection, tighten belt again, adjust the light path until less than 3 mm, then the right Y axis of the synchronous belt (upper By tube) Adjust the tie rod to relax, to the adjustment of the bottom rod screw locking, fine-tuning the light path, so repeated several times until the diagonal as long.