ZuoLong mechanical thumb: how to adjust the welding machine light path

How to adjust the welding machine light path? Many new customers after the purchase of welding machine, to adjust the light path that is strange, but welding word vendors would will be training to the customer. However, there are a lot of customers will have operation method to forget very quickly, so now give you arrange a tutorial about welding machine optical path adjustment for your reference.

why do you want to adjust the light path? The welding machine itself are flying light path system, in the long-term work, the light path can produce slight deviation, will have great influence for the cutting effect. Therefore, regularly check that the light path and adjustment is very necessary. Attention:



1 first light adjustment, in the mirror with crepe paper dimming target hole, A manual point move out of the light ( Note don't use too much power at this time) , fine-tuning the mirror A base and tube support, make the light in the center of the target hole, pay attention to the light cannot be blocked.

2 second light adjustment, remove the mirror B to remote, with a piece of cardboard from near to far out of the light, the light transmitting into the cross light target, because the remote light is in the target and the proximal target must be in the inside, and then turn the proximal and remote spot is consistent, namely how the proximal partial, remote follow how partial, also make the cross in the proximal and remote spot are all in the same position that is close to, Far is) State road and parallel to the Y axis guide light.

3 third light adjustment ( Note: the cross will flare around the points) Mirror C, be moved to the remote, the light transmitting into the light target, in the end and the remote the shooting time, contrast the position of the cross into GenJin end flare in the position of the cross, then show that beam parallel to the X axis. Inside or outside, this time road is the frame must be B on the M1, M2, and M3 with loose or tight, until around the points.

4 the adjustment of the fourth light, with a stick in the crepe paper on the light, use the light hole left a round mark on the tape, and points out the light, remove the tape observation hole position, as the case to adjust the frame C M1, M2, and M3 until flare round and is.

the focal length measurement methods:

with our welding word vendors would match the focal length of the foot, put the nozzle lift up and down in the focal length of feet above the number 5, where the light is bright and strong, then lock screw.

we want more welding machine price, welcome to inquire, hotline: